000016053 Ice Water Level Sensor Probe Kit with Harness for Manitowoc Ice Maker

Ice Water Level Sensor Probe Kit for Manitowoc Ice Maker

This ice water level sensor probe kit with harness replaces the water level sensing assembly in Manitowoc ice makers, restoring accurate fill control so the machine cycles correctly through freeze and harvest. The kit carries part number 000016053 and includes the probe and wiring harness for a direct swap.

Overview

This ice water level sensor probe kit for Manitowoc ice maker machines provides the water level sensor and harness needed to bring ice production back to spec. It monitors sump water level so the controller pours the right amount of water during each cycle. It suits service techs and operators doing a straightforward repair on a stalled or overfilling ice machine.

Built For Performance

• Water level sensing probe engineered for consistent fill detection
• Included wiring harness for a complete plug-in replacement
• Fits part number 000016053 applications directly
• Compatible with Manitowoc ice maker water level circuits
• Fully assembled for straightforward installation

Fits These Machines

• for Manitowoc ice makers that use part 000016053

On-The-Job Use

• Ice machine service and repair
• Restaurants, bars, and foodservice kitchens
• Commercial ice production lines
• Preventive maintenance on Manitowoc ice makers

Specs At A Glance

Good To Know

Q: Does this kit include the harness? A: Yes, the kit ships with both the water level sensor probe and its wiring harness. It is designed as a complete replacement for part 000016053.

Q: Will this fix an ice machine that keeps overfilling? A: A failed water level sensor often causes overfill or improper fill timing, and replacing the probe and harness typically restores normal operation. Confirm your machine uses part 000016053 before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.