010-12528-30 Marine Network Cable 6.5 ft./2 m, Small Connector, for GLS 10

Marine Network Cable for Garmin GLS 10

This 6.5 ft. (2 m) marine network cable with a small connector links your GLS 10 sonar module to a compatible Garmin marine network, giving you a reliable data path on the water.

Overview

This marine network cable is a 6.5 ft. (2 m) small connector cable built to connect a GLS 10 module to a compatible marine network. It carries sonar and system data between networked devices so your helm electronics stay in sync. It is intended for boaters adding or replacing a network run for a GLS 10 setup.

Built For Performance

• 6.5 ft. (2 m) length suits short runs between helm components
• Small connector designed for marine network ports
• Shielded cable construction helps reduce signal interference on board
• Marine-grade jacket stands up to moisture and sun exposure
• Plug-and-play connection with no cutting or splicing needed

Fits These Machines

• for Garmin GLS 10 sonar module
• for Garmin marine network devices with a small connector port

On-The-Job Use

• Connecting a GLS 10 module to a helm network hub
• Replacing a damaged or corroded network run on a boat
• Extending a marine network between console and transom areas
• New electronics installs on center consoles and cabin boats

Specs At A Glance

Good To Know

Q: Will this cable work with any Garmin marine network device? A: It is built for devices that use the small connector port, including the GLS 10 module. Check your unit's port style before ordering.

Q: Can this cable be run through a boat's rigging tube? A: Yes, the small connector and 6.5 ft. length make it manageable for short runs through rigging tubes. Avoid sharp bends that could stress the cable.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.