1.25" Crash Bar Engine Guard Highway Bar For 2000-17 Harley Fatboy FLSTF FLSTFI

1.25" Crash Bar Engine Guard Highway Bar for Harley Fatboy FLSTF FLSTFI

This 1.25 inch crash bar engine guard highway bar provides front-end protection and highway peg mounting for 2000-2017 Harley Fatboy FLSTF and FLSTFI models.

Overview

This engine guard highway bar is a heavy-duty front crash bar set built to shield the lower engine and frame in a tip-over while giving riders a place to stretch their legs on long rides. Sized at 1.25 inches in diameter, this crash bar fits 2000-2017 Harley Fatboy FLSTF and FLSTFI models that use 1.25 inch diameter bars. Riders replacing a bent or missing factory guard, or adding protection to a stock bike, get a direct-mount engine guard highway bar that keeps the classic Fatboy profile intact.

Built For Performance

• 1.25 inch outer diameter tubing for a substantial, factory-style bar profile
• Steel construction built to absorb impact and resist flex under load
• Black powder-coated finish for corrosion resistance and a clean look
• Pre-bent geometry that follows the Fatboy frame and avoids the exhaust and controls
• Mounting points positioned for direct bolt-on fitment to the frame
• Uniform bar diameter across the full span for even clamping of highway pegs or clamps

Fits These Machines

• for Harley Fatboy FLSTF 2000-2017
• for Harley Fatboy FLSTFI 2000-2017
• for Harley Softail Fatboy models running 1.25 inch diameter bars

On-The-Job Use

• Protecting the engine cases and frame during low-speed tip-overs
• Adding a mounting point for highway pegs on long-distance rides
• Restoring front-end protection after a bent or damaged factory guard
• Refreshing the front of a stock Fatboy with a cleaner, wider bar look

Specs At A Glance

Good To Know

Q: Will this bar bolt to my stock Fatboy without cutting or welding? A: This engine guard is designed as a direct-mount bar for 2000-2017 Fatboy FLSTF and FLSTFI models, so it attaches using the existing frame mounting points. No cutting or welding is required for standard installation.

Q: Can I mount highway pegs on this crash bar? A: Yes, the 1.25 inch diameter tubing accepts standard 1.25 inch clamp-on highway peg kits. Check that your peg clamps match the 1.25 inch bar diameter before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.