12Pcs Front Lower Control Arm Ball Joint Tie Rods Sway Bars for Mazda 3 Mazda 5

Front Suspension Kit for Mazda 3 and Mazda 5

This 12-piece front lower control arm, ball joint, tie rod, and sway bar kit restores steering response and ride stability for Mazda 3 and Mazda 5 owners replacing worn front-end components.

Overview

This 12-piece front suspension kit bundles lower control arms, ball joints, tie rods, and sway bar components into one rebuild set for Mazda 3 and Mazda 5 vehicles. Each part is engineered to restore factory steering feel and tighten front-end geometry after wear. It suits DIY mechanics and shops handling a complete front-end refresh in a single job.

Built For Performance

• Forged and stamped steel construction for durability under load
• Pre-installed ball joints on control arms to cut installation time
• Greaseable fittings on tie rod ends for extended service life
• Corrosion-resistant coating on metal surfaces
• Rubber bushings tuned for factory-like ride compliance
• Direct-fit geometry matching original mounting points

Fits These Machines

• for Mazda 3
• for Mazda 5

On-The-Job Use

• Front-end rebuilds after clunking or loose steering
• Alignment correction following control arm wear
• Routine suspension refresh on high-mileage vehicles
• Collision repair requiring replacement of bent front components

Specs At A Glance

Good To Know

Q: Does this kit include both driver and passenger side parts? A: Yes, the 12-piece set covers both sides of the front suspension for a complete rebuild. Confirm your model year before ordering.

Q: Is an alignment needed after installation? A: Yes, a professional alignment is recommended after replacing control arms or tie rods. This ensures proper toe and camber settings.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.