12x Front Lower Control Arm Ball Joint Tie Rod End For 2011-2017 Ford Explorer

Front Lower Control Arm Ball Joint Tie Rod End Kit for Ford Explorer

This 12-piece front end kit supplies lower control arm, ball joint, and tie rod end components to rebuild the steering and suspension on 2011-2017 Ford Explorer models.

Overview

This front lower control arm ball joint tie rod end kit covers the wear parts that loosen up on high-mileage Ford Explorer front suspensions. Replacing the control arms, ball joints, and tie rod ends together restores steering response and helps correct irregular tire wear. It suits DIY mechanics and shops handling a complete front end refresh in one job.

Built For Performance

• 12-piece kit covers both sides of the front suspension and steering linkage
• Lower control arm assemblies with pressed-in ball joints
• Tie rod ends restore accurate steering input and alignment angles
• Ball joints pivot freely for smooth suspension travel
• Direct-fit geometry for 2011-2017 Ford Explorer front ends

Fits These Machines

• for Ford Explorer 2011
• for Ford Explorer 2012
• for Ford Explorer 2013
• for Ford Explorer 2014
• for Ford Explorer 2015
• for Ford Explorer 2016
• for Ford Explorer 2017

On-The-Job Use

• Replacing clunking or worn front suspension parts
• Correcting loose steering and vague handling
• Front end rebuilds before an alignment
• Fixing uneven or accelerated tire wear

Specs At A Glance

Good To Know

Q: Do I need an alignment after installing this kit? A: Yes, replacing control arms and tie rod ends changes suspension geometry, so a professional alignment is required afterward. Drive only to the alignment shop once installed.

Q: Is this kit for one side or both sides? A: It is a 12-piece front kit intended to service both sides of the vehicle. Confirm the piece count matches your repair plan before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.