14 M ID SIDB Y Splitter Cable 720111-1 for Humminbird SOLIX/APEX/XPLORE 30-Inch

14 M ID SIDB Y Splitter Cable for Humminbird SOLIX/APEX/XPLORE

The 14 M ID SIDB Y Splitter Cable 720111-1 for Humminbird splits a single transducer signal path so two sonar displays can share one installation, with a 30-inch run for flexible routing.

Overview

This 14 M ID SIDB Y Splitter Cable works as a signal-sharing harness for select Humminbird sonar setups, letting one transducer feed two displays through the 720111-1 connector arrangement. The 30-inch 14 M ID SIDB Y Splitter Cable keeps runs short and tidy behind the console. It suits anglers running dual units on one boat who want a clean, direct connection.

Built For Performance

• 14 M ID SIDB Y configuration splits one signal path between two units
• 720111-1 cross-reference matches the listed compatible applications
• 30-inch cable length provides routing room without excess slack
• Molded connectors resist moisture and vibration in marine settings
• Shielded conductors help limit interference between connected units

Fits These Machines

• for Humminbird SOLIX series units
• for Humminbird APEX series units
• for Humminbird XPLORE series units

On-The-Job Use

• Sharing a single transducer between two sonar displays
• Consoles with limited transducer mounting positions
• Freshwater and saltwater fishing boats
• Retrofit wiring on existing Humminbird installations

Specs At A Glance

Good To Know

Q: Does this cable let me run two displays from one transducer? A: Yes, a Y splitter routes the transducer signal to two units at once. Confirm your head units and transducer accept this connector type before ordering.

Q: Is the 30-inch length enough for a typical console install? A: It covers most short runs between a transducer and nearby displays. Measure your planned route to confirm the length suits your layout.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.