16Pcs Suspension Front Control Arm Kit for 2011-19 Dodge Charger Challenger 300

Front Control Arm Kit for Dodge Charger Challenger 300

This 16-piece suspension front control arm kit replaces worn factory arms, ball joints, and bushings on 2011-2019 Dodge Charger, Challenger, and Chrysler 300 models for restored steering response and alignment.

Overview

This 16Pcs suspension front control arm kit restores proper camber, caster, and toe on 2011-2019 Dodge Charger, Challenger, and Chrysler 300 models. The front control arm kit replaces tired ball joints and bushings that cause wandering and uneven tire wear. It suits daily drivers and performance owners needing a complete front-end refresh.

Built For Performance

• 16-piece set covering upper and lower front control arms
• Pre-installed ball joints for direct bolt-on replacement
• Rubber bushings tuned for street comfort and control
• Steel construction for durability under load
• Fits both driver and passenger sides

Fits These Machines

• for Dodge Charger 2011-2019
• for Dodge Challenger 2011-2019
• for Chrysler 300 2011-2019

On-The-Job Use

• Front-end rebuilds after worn bushings or ball joints
• Alignment corrections on daily-driven sedans
• Suspension refresh for high-mileage Charger and Challenger
• Repair of clunking and steering wander

Specs At A Glance

Good To Know

Q: Do I need an alignment after installing this front control arm kit? A: Yes, an alignment is required after replacing control arms to set camber, caster, and toe. Driving before alignment can cause rapid tire wear.

Q: Is this kit for one side or both sides? A: The 16-piece set covers both driver and passenger front sides. Check the listing contents against your vehicle before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.