2 Front or Rear Wheel Hub Bearings Assembly for Audi A4 A5 A6 A7 A8 Q5 S4 513301

Front or Rear Wheel Hub Bearings Assembly for Audi

This wheel hub bearings assembly is a direct-fit replacement unit for Audi A4, A5, A6, A7, A8, Q5, and S4 models, cross-referenced under OEM number 513301, and it restores smooth, quiet rotation at the wheel while carrying the vehicle's load on the road.

Overview

This wheel hub bearings assembly is built to replace a worn or noisy hub on Audi A4, A5, A6, A7, A8, Q5, and S4 models. It combines the hub flange and bearing into one sealed unit so the wheel spins true and the ABS sensor reads cleanly. It suits DIY installers and independent shops handling a bearing replacement or a brake job that turns into a hub refresh.

Built For Performance

• Sealed bearing design keeps grease in and road grit out
• Pre-assembled hub and bearing unit simplifies installation
• Machined hub flange for accurate wheel mounting
• Integrated tone ring for ABS sensor readings
• Bearing races hardened for extended service life
• Factory-matched dimensions for a direct replacement fit

Fits These Machines

• for Audi A4
• for Audi A5
• for Audi A6
• for Audi A7
• for Audi A8
• for Audi Q5
• for Audi S4

On-The-Job Use

• Replacing a noisy or loose wheel bearing
• Restoring ABS tone ring signal at the hub
• Brake and suspension service where the hub is removed
• Routine maintenance on high-mileage Audi models

Specs At A Glance

Good To Know

Q: Do I need a press to install this hub? A: Most applications bolt the assembly to the knuckle or axle, and a press is typically not required. Check your model's service procedure before starting.

Q: Should hubs be replaced in pairs? A: Replacing both sides of an axle at once is common practice when mileage is similar. Follow your inspection results to decide.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.