2 Front Wheel Hub Bearing Steering Knuckle 698-450 698-451 for Honda Civic 06-11

Front Wheel Hub Bearing Steering Knuckle for Honda

This pair of front wheel hub bearing and steering knuckle assemblies replaces OEM 698-450 and 698-451 for the 2006-2011 Honda Civic, supporting the wheel while allowing it to turn and spin smoothly.

Overview

These front wheel hub bearing steering knuckle assemblies are complete corner units that let you replace a worn or damaged knuckle and bearing in one shot for the 2006-2011 Honda Civic. Each steering knuckle carries the hub bearing, so the wheel mounts and pivots as intended while the bearing supports the load. Ideal for DIYers and shops doing accident repair or drivetrain refresh on a Honda Civic.

Built For Performance

• Complete assembly with hub bearing pre-installed in the knuckle
• Direct cross-reference to OEM 698-450 and 698-451
• Sold as a pair for both front corners
• Steel construction built for daily driving loads
• Bolt-on replacement for faster job turnaround

Fits These Machines

• for Honda Civic 2006
• for Honda Civic 2007
• for Honda Civic 2008
• for Honda Civic 2009
• for Honda Civic 2010
• for Honda Civic 2011

On-The-Job Use

• Front corner rebuild after collision damage
• Replacing a noisy or seized wheel bearing
• Restoring steering geometry on a high-mileage Civic
• General front suspension and drivetrain refresh

Specs At A Glance

Good To Know

Q: Is this sold as a pair? A: Yes, this listing covers both front hub bearing steering knuckle assemblies so you can service both sides of the Honda Civic in one job.

Q: Do I need to press in the bearing? A: No, the bearing comes pre-installed in the knuckle, so the assembly bolts on as a complete front corner unit.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.