2×Throttle Body Intake Manifold Boot For Polaris RZR 4 XP 900 2011-2013

2x Throttle Body Intake Manifold Boot for Polaris RZR 4 XP 900

This 2x throttle body intake manifold boot for Polaris RZR 4 XP 900 is a replacement intake boot set that seals the throttle body to the intake manifold on 2011-2013 RZR 4 XP 900 models.

Overview

This 2x throttle body intake manifold boot for Polaris RZR 4 XP 900 is a replacement intake boot set for side-by-side models from 2011 to 2013. Each throttle body intake manifold boot carries the throttle charge from the throttle body to the intake manifold and prevents unfiltered air from entering the engine. RZR 4 XP 900 owners and technicians use these boots when replacing cracked, collapsed, or hardened intake rubber during a rebuild.

Built For Performance

• Set of two throttle body intake manifold boots for the Polaris RZR 4 XP 900 platform
• Molded boot opening helps align with the throttle body bore and intake face
• Flexible body follows the factory intake routing without collapsing
• Sealing surface works with the spring clamps used on the intake assembly
• Replaces damaged boots before they cause dirt entry or vacuum leaks

Fits These Machines

• for Polaris RZR 4 XP 900 2011-2013

On-The-Job Use

• Replaces a rotted throttle boot during a full RZR 4 XP 900 intake service
• Restores the sealed joint between the throttle body and manifold during repair
• Often used after hard trail riding when the original boots are brittle or torn
• Useful for fixing rough idle or inconsistent fuel delivery caused by intake air leaks

Specs At A Glance

Good To Know

Q: Are these boots sold as a pair? A: Yes, this set includes two throttle body intake manifold boots to replace both intake connections in the same service.

Q: What happens if a throttle boot is left cracked? A: A cracked boot can allow unfiltered air into the intake and cause lean running, rough idle, or poor throttle response. Replacing both boots restores a sealed intake track.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.