285mm 980lbs Rear Shock Absorber Suspension for 125 140 150cc Pit Dirt Bikes Atv

285mm Rear Shock Absorber for Pit Bikes and ATVs

This 285mm rear shock absorber delivers 980lbs of spring support for 125cc, 140cc, and 150cc pit dirt bikes and ATVs, giving riders a direct replacement for worn or blown rear suspension.

Overview

This rear shock absorber is a 285mm suspension unit rated at 980lbs, built to restore rear-end control on 125cc, 140cc, and 150cc pit dirt bikes and ATVs. It absorbs impacts from jumps, bumps, and rough trails so the rear wheel stays planted and the chassis stays stable. Riders replacing a sagging or leaking stock shock will find this rear shock absorber a practical bolt-on solution for trail and track use.

Built For Performance

• 285mm eye-to-eye length matches common pit bike and ATV rear suspension geometry
• 980lbs spring rate supports aggressive riders and heavier loads
• Coil-over design with hydraulic damping for controlled compression and rebound
• Steel spring and alloy body resist corrosion from mud and moisture
• Preload adjustment lets riders fine-tune ride height and stiffness

Fits These Machines

• For 125cc pit dirt bikes
• For 140cc pit dirt bikes
• For 150cc pit dirt bikes
• For 125cc to 150cc ATVs

On-The-Job Use

• Trail riding and woods sections where rear traction matters
• Motocross and pit bike track sessions with jumps and whoops
• ATV trail and utility riding over roots and ruts
• Replacing a worn or blown factory rear shock

Specs At A Glance

Good To Know

Q: Will this shock fit my pit bike? A: Measure your current shock eye-to-eye; it must match 285mm for correct fit. Mounting bolt diameter and bushing style should also match your bike.

Q: Is the spring rate adjustable? A: Yes, preload can be adjusted to tune sag and stiffness for your weight and riding style. Set sag before riding hard.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.