2PACK Front Shaft CV Axle 1333943 1333420 1333283 For Polaris RZR XP 1000 XP 4

Front CV Axle Half Drive Shaft 2-Pack for Polaris RZR XP 1000 XP 4

This two-pack of front CV axle half drive shafts fits Polaris RZR XP 1000 and XP 4 models, cross-referencing OEM numbers 1333943, 1333420, and 1333283 for both sides of the front driveline.

Overview

This 2-pack of front CV axle half drive shafts is designed for Polaris RZR XP 1000 and XP 4 machines that need both front axles replaced at once. Each shaft carries power from the front differential to the wheel hub, keeping the front wheels driving under load. It is a practical choice for owners servicing a Polaris RZR XP 1000 CV axle on both sides in a single job.

Built For Performance

• Two complete front axles in one set for left and right replacement
• Cross-references OEM numbers 1333943, 1333420, and 1333283
• Heat-treated steel shafts built for off-road torque demands
• Pre-packed CV joints with boots installed for faster service
• Assemblies balanced to help reduce vibration
• Corrosion-resistant finish on shafts and joint housings

Fits These Machines

• for Polaris RZR XP 1000
• for Polaris RZR XP 4 1000

On-The-Job Use

• Replacing both front axles after torn boots or joint noise
• Trail and desert riding that loads the front driveline
• Mud and water use where sealed joints matter
• Servicing a machine before a long riding season

Specs At A Glance

Good To Know

Q: Do both axles in this set fit the same machine? A: Yes, the set is intended for the front position on Polaris RZR XP 1000 and XP 4 models, covering left and right sides. Confirm the OEM numbers against your current shafts before ordering.

Q: Are these original Polaris axles? A: No, these are aftermarket replacement axles that cross-reference the listed OEM numbers. They are not manufactured or sold by Polaris.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.