2Pcs -10AN AN10 Flare Fuel Cell Bulkhead Fitting With Teflon Washer Aluminum

-10AN AN10 Flare Fuel Cell Bulkhead Fitting

This -10AN AN10 flare fuel cell bulkhead fitting with Teflon washer passes fuel or fluid lines through a cell wall or panel with a sealed flare connection.

Overview

This -10AN AN10 flare fuel cell bulkhead fitting mounts through a tank or panel wall so a fuel line can pass through with a sealed connection. Supplied as a pair with Teflon washers, the AN10 bulkhead fitting gives builders a clean pass-through point for fuel cell and fluid line plumbing. It suits racers and fabricators setting up fuel systems on custom builds.

Built For Performance

• -10AN AN10 flare connection for standard hose ends and adapters
• Bulkhead design mounts through a cell wall or panel for a pass-through point
• Teflon washers help seal the fitting against the mounting surface
• Sold as a pair for both sides of a single line or two separate lines
• Aluminum construction keeps weight down on race builds

On-The-Job Use

• Fuel cell plumbing on race cars
• Custom fuel system fabrication
• Fluid line pass-throughs on tanks and panels
• Remote mount fuel setups

Specs At A Glance

Good To Know

Q: What does the Teflon washer do? A: It seals the fitting against the mounting surface where the bulkhead passes through the wall. Replace it if it gets nicked or crushed during install.

Q: Can I use these on a fuel cell? A: Yes, they are made for fuel cell and panel pass-throughs with -10AN flare connections. Confirm your wall thickness and hose end size before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.