2Pcs 2.5" Inch Butt Joint Band Exhaust Clamp Sleeve Coupler T304 Stainless Steel

2.5 Inch Butt Joint Band Exhaust Clamp Sleeve Coupler for T304 Stainless Steel

This 2.5 inch butt joint band exhaust clamp sleeve coupler joins two pipes end to end with a wide stainless steel band and T304 grade construction.

Overview

This butt joint band exhaust clamp sleeve coupler connects two 2.5 inch pipes for a clean, leak-resistant joint. The T304 stainless steel build resists corrosion from road salt, moisture, and exhaust heat. It is a practical choice for exhaust shops and DIY repairs on stock or custom systems.

Built For Performance

• T304 stainless steel resists rust and heat discoloration
• 2.5 inch diameter fits standard exhaust tubing
• Wide band spreads clamping force for a tight seal
• Butt joint sleeve design aligns two pipe ends evenly
• Reusable and serviceable compared to welded joints

On-The-Job Use

• Joining exhaust pipe sections during repair
• Installing mufflers, resonators, and cat-back kits
• Custom exhaust fabrication and modifications
• Replacing rusted or failed factory clamps

Specs At A Glance

Good To Know

Q: Do I need to weld this coupler to the pipes? A: No, it is a clamp-on sleeve that bolts over the joint. Welding is optional for a permanent connection.

Q: Will this fit 2.5 inch pipe exactly? A: Yes, it is sized for 2.5 inch outside diameter tubing. Measure your pipe before ordering to confirm.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.