2Pcs Rear CV Axle Drive Shaft For Polaris Ranger Crew XP 1000 2017 2018 2019

Rear CV Axle Drive Shaft for Polaris Ranger Crew XP 1000

This pair of rear CV axle drive shafts transfers engine power to the rear wheels on Polaris Ranger Crew XP 1000 side-by-side vehicles, available as a direct-fit replacement set for worn or damaged factory axles.

Overview

This 2-piece rear CV axle drive shaft set is built to restore power delivery to the rear wheels of Polaris Ranger Crew XP 1000 machines. Each rear CV axle drive shaft in this set matches the factory mounting points so installation stays straightforward for DIY mechanics and shops alike. Sold as a pair, it keeps both rear corners running on fresh axles at once.

Built For Performance

• Constant velocity joints allow smooth power transfer through steering and suspension travel
• Heat-treated steel shaft resists twisting under heavy torque loads
• Protective CV boots seal out dirt, water, and debris
• Balanced construction helps reduce vibration at speed
• Direct-fit splines and mounting points for straightforward replacement
• Sold as a set of two for both rear wheel positions

Fits These Machines

• for Polaris Ranger Crew XP 1000 (2017)
• for Polaris Ranger Crew XP 1000 (2018)
• for Polaris Ranger Crew XP 1000 (2019)

On-The-Job Use

• Trail riding and wooded terrain where axle stress builds quickly
• Farm and ranch chores with frequent starts, stops, and loaded travel
• Hauling and towing tasks that push torque through the rear drivetrain
• Mud, water crossings, and dusty conditions that wear CV boots and joints
• Replacing a snapped or clicking axle after a season of hard use

Specs At A Glance

Good To Know

Q: How do I know if my rear CV axle needs replacing? A: Common signs include clicking or popping during turns, torn CV boots with grease loss, vibration at speed, or visible play in the joint. Any of these usually points to a worn rear CV axle that should be swapped out.

Q: Can I install these axles myself? A: Yes, rear CV axle replacement on a Polaris Ranger Crew XP 1000 is a common DIY job with basic hand tools and jack stands. If you are unsure about torque specs or suspension removal, have a qualified mechanic handle the install.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.