2x Front Side Lower Control Arm Ball Joint For Acura MDX ZDX 2007-2013

Front Lower Control Arm Ball Joint for Acura MDX and ZDX

These front side lower control arm ball joints are direct replacement suspension components for Acura MDX and ZDX models, restoring proper steering pivot movement and front end alignment.

Overview

This pair of front lower control arm ball joints replaces worn pivot points on Acura MDX and ZDX models, bringing back responsive steering and stable tracking. Each ball joint is built to handle the load of the front suspension on a crossover platform. It suits owners and shops handling routine front end suspension repair on these models.

Built For Performance

• Sold as a pair to service both sides of the front end
• Front lower control arm position for direct replacement
• Ball stud design allows proper steering pivot movement
• Forged and machined housing for suspension load handling
• Integrated boot helps retain grease and block contaminants
• Fits 2007 through 2013 Acura MDX and ZDX applications

Fits These Machines

• for Acura MDX 2007-2013
• for Acura ZDX 2007-2013

On-The-Job Use

• Replacing clunking or loose front lower ball joints
• Front end refresh during alignment service
• Correcting steering wander and uneven tire wear
• Suspension repair after curb or pothole impact

Specs At A Glance

Good To Know

Q: Do I need new hardware when installing these ball joints? A: Reusing original nuts and bolts is sometimes possible, but new hardware is recommended on suspension work. Inspect the control arm and knuckle for wear at the same time.

Q: Should the vehicle be aligned after installation? A: Yes, an alignment is standard after replacing front lower ball joints, since suspension geometry changes once new parts are fitted.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.