2x Rear Leaf Spring Rear Hanger Bracket and Shackle Kit for Ford Ranger Mazda

Rear Leaf Spring Hanger Bracket and Shackle Kit for Ford Ranger and Mazda

This rear leaf spring hanger bracket and shackle kit replaces the worn mounting points on the rear leaf springs of compatible Ford Ranger and Mazda trucks, restoring proper spring geometry and ride height.

Overview

This rear leaf spring hanger bracket and shackle kit supplies the two rear hanger brackets and shackles needed to re-mount the rear leaf springs. The kit is built for Ford Ranger and Mazda pickup owners dealing with rusted, cracked, or collapsed factory hangers. Each piece is a direct-style replacement for the rear leaf spring mounting hardware on these trucks.

Built For Performance

• Two rear leaf spring hanger brackets included
• Matching shackle kit for the rear spring eyes
• Heavy gauge steel construction for load-bearing strength
• Fits the rear spring mount locations on compatible Ford Ranger and Mazda trucks
• Bolt-on replacement for original mounting points

Fits These Machines

• for Ford Ranger rear leaf spring applications
• for Mazda pickup rear leaf spring applications

On-The-Job Use

• Repairing rusted or broken rear spring hangers
• Restoring rear ride height after a hanger fails
• Suspension rebuilds on older Ranger and Mazda trucks
• Preventive replacement on high-mileage work trucks

Specs At A Glance

Good To Know

Q: Do I need to remove the leaf springs to install this kit? A: In most cases the rear spring must be supported or lowered so the old hanger can be cut or unbolted and the new one fitted. A shop press or floor jack helps with the swap.

Q: Is this sold as a pair? A: Yes, the kit covers both rear hanger brackets and shackles. Confirm your truck's rear spring setup before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.