32.5" Rear Suspension Stabilizer Sway Bar Fits For Polaris RZR 800 S 4 2010-2014

Rear Suspension Stabilizer Sway Bar for Polaris

This 32.5 inch rear suspension stabilizer sway bar is a replacement anti-roll component for Polaris RZR 800 S 4 models from 2010 through 2014, working to reduce body roll and keep the rear end planted through corners and uneven terrain.

Overview

This rear suspension stabilizer sway bar is built to replace a worn or broken factory bar on Polaris RZR 800 S 4 machines from 2010 to 2014. The stabilizer sway bar links the rear suspension arms to limit side-to-side lean, which helps keep the tires planted when you corner or cross rutted ground. It suits riders doing routine upkeep on a UTV that sees regular trail and work use.

Built For Performance

• 32.5 inch overall length sized for the rear suspension of the RZR 800 S 4 platform
• Solid bar construction resists flex under hard cornering loads
• Preformed bends follow the factory mounting path for a direct fit
• Corrosion-resistant finish helps the bar hold up to mud and moisture
• Works with the existing rear stabilizer bushings and end links

Fits These Machines

• for Polaris RZR 800 S 4 2010
• for Polaris RZR 800 S 4 2011
• for Polaris RZR 800 S 4 2012
• for Polaris RZR 800 S 4 2013
• for Polaris RZR 800 S 4 2014

On-The-Job Use

• Trail riding where rear body roll needs to be controlled
• Cornering on two-track and fire roads
• Replacing a bent or rusted factory sway bar
• Routine rear suspension refresh on an older RZR 800 S 4

Specs At A Glance

Good To Know

Q: Do I need new bushings with this sway bar? A: Reusing old bushings is possible if they are still soft and intact, but installing fresh bushings is the safer route since worn rubber will undo much of the bar's benefit.

Q: Will this fit a standard RZR 800 rather than the S 4? A: This bar is listed for the RZR 800 S 4 model range, and other RZR 800 variants can use different rear bar lengths, so compare your machine's measurement before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.