331003KA0B Transfer Case Assembly 2014-2019 for Infiniti QX60 Nissan Murano 3.5L

Transfer Case Assembly for Infiniti QX60 and Nissan Murano

This transfer case assembly replaces the OEM unit referenced by part number 331003KA0B to route drive torque to the front axle on all-wheel drive 3.5L models.

Overview

This transfer case assembly is a direct replacement component for the all-wheel drive system on 2014 to 2019 Infiniti QX60 and Nissan Murano 3.5L vehicles. The transfer case assembly sends power from the transmission to the front and rear axles, keeping traction steady on wet roads and loose surfaces. It suits owners and shops handling driveline repair on these crossover platforms.

Built For Performance

• Housing cast to match the OEM 331003KA0B mounting footprint
• Internal gearing cut to deliver dependable torque split to both axles
• Sealed case design keeps lubricant contained and debris out
• Machined input and output flanges for accurate driveline alignment
• Built to withstand the loads of V6 all-wheel drive operation

Fits These Machines

• for Infiniti QX60 3.5L 2014-2019
• for Nissan Murano 3.5L 2014-2019

On-The-Job Use

• Restoring all-wheel drive function after transfer case failure
• Driveline service on family crossover vehicles
• Replacing a leaking or noisy original unit
• Shop repair work on 3.5L all-wheel drive platforms

Specs At A Glance

Good To Know

Q: Does this transfer case fit both the Infiniti QX60 and Nissan Murano? A: It is listed for the 2014 to 2019 3.5L models of both vehicles under part number 331003KA0B, but you should confirm your trim and driveline before ordering.

Q: Is this an original manufacturer part? A: This is an aftermarket replacement transfer case assembly built to match the original unit's fit and function, and it is not produced by Infiniti or Nissan.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.