350 CFM 2-barrel Carburetor For 0-80350 Street Avenger Carburetor Electric Choke

350 CFM 2-Barrel Carburetor for Street Avenger 0-80350 with Electric Choke

This 350 CFM 2-barrel carburetor is an electric choke replacement unit matched to the 0-80350 Street Avenger reference, built to meter fuel cleanly on smaller displacement and stock V8 engines.

Overview

This 350 CFM 2-barrel carburetor provides controlled fuel and air delivery for engines that need moderate flow rather than race-level volume. The electric choke handles cold starts automatically so the engine settles into a steady idle without manual input. It fits daily drivers, light trucks, and small V8 or V6 builds where economy and drivability matter most.

Built For Performance

• 350CFM 2-barrel flow rating suits small displacement and lightly modified engines
• Electric choke delivers automatic cold start enrichment
• Two barrel design keeps part-throttle fuel economy in check
• Direct replacement footprint for common square bore intake patterns
• 0-80350 reference number allows cross-checking against the Street Avenger listing
• Vacuum and throttle linkage provisions for straightforward installation

Fits These Machines

• for Street Avenger 0-80350 applications

Specs At A Glance

On-The-Job Use

• Stock and mild V8 street engines needing steady fuel metering
• Light trucks and vans used for daily hauling and commuting
• Small displacement builds where a larger 4 barrel would over-fuel
• Replacement on engines with an existing 2 barrel intake manifold

Good To Know

Q: How does the electric choke on this 350 CFM 2-barrel carburetor work? A: The electric choke uses a heated element that opens the choke plate as the engine warms, so cold starts enrich automatically and then taper off. It needs a switched 12V source wired to the choke housing for correct operation.

Q: Will this replace a Street Avenger 0-80350 directly? A: It is built to the same 350CFM 2-barrel specification and carries the 0-80350 reference for comparison. Always verify throttle linkage, fuel inlet position, and intake bolt pattern against your engine before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.