396644 Johnson Evinrude 4 4.5 6 8 HP Outboard Water Pump Rebuild Kit 0396644

Water Pump Rebuild Kit for Johnson Evinrude 4 4.5 6 8 HP Outboard 0396644

This water pump rebuild kit for Johnson Evinrude outboards is a replacement set of parts that restores the coolant pump performance of a 4 HP, 4.5 HP, 6 HP and 8 HP marine motor, using reference number 0396644.

Overview

This water pump rebuild kit for Johnson Evinrude small outboards provides the key components that wear out inside a damp body plumbing, allowing the water pump to pull seawater over engine pressure. It is an aftermarket service kit designed for the Johnson Evinrude water pump assembly in hp tips section.

Built For Performance

• Reconstructure the water pump impeller drive inside the pump cap
• Provides a water pump seal kit specifically for the 4-8 HP outboard engine block
• Includes rubber parts around the flexible a collar, recess and housing plate
< FASL
• Package for outboard engine houses contact area and needle shaft
• Ready to use when servicing wet lists

Fits These Machines

• for Johnson Evinrude 4 HP Outboard
• for Johnson Evinrude 4.5 HP Outboard
• for Johnson Evinrude 6 HP Outboard
• for Johnson Evinrude 8 HP Outboard

On-The-Job Use

• Replace worn rubber pump components over draining water service
• Rebuild water pump while lower unit is split on a bench
• Pickup boat mis/preventive service at rampside
• Restore proper water intake to an outboard after wear

Specs At A Glance

Good To Know

Q: What is included in the rebuild set?A: This is a water pump rebuild kit that contains the flexing pump parts necessary to reset the work, but not a full housing so the old housing continues to be used.

Q: What should I check first?A: As the replacement is made, compare the backplate gasket to the old pump cavity housing绝大多数 before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.