4 Bolt 102mm Throttle Body & TPS IAC+Throttle Cable For GM Gen III LS1 LS2 LS6

Throttle Body for GM

This 4 bolt 102mm throttle body with TPS, IAC, and throttle cable provisions is built for GM Gen III LS1, LS2, and LS6 engines.

Overview

This 102mm throttle body for GM Gen III LS1, LS2, and LS6 engines is a four-bolt unit that meters incoming air into the intake manifold. It comes with a throttle position sensor, idle air control provision, and throttle cable hookup for cable-driven setups. The throttle body suits engine swaps, builds, and replacement on GM LS platform applications.

Built For Performance

• 102mm bore size for increased airflow over stock throttle bodies
• Four-bolt mounting flange for a secure seal to the intake manifold
• Throttle position sensor included for plug-in throttle signal
• Idle air control provision for stable idle control
• Throttle cable connection for cable-driven throttle linkage
• Machined aluminum body construction

Fits These Machines

• for GM Gen III LS1 engines
• for GM LS2 engines
• for GM LS6 engines

On-The-Job Use

• Engine swaps running GM Gen III LS platforms
• Replacing a worn or damaged factory throttle body
• Builds needing a larger 102mm bore for more airflow
• Cable-driven throttle setups on LS1, LS2, and LS6 engines

Specs At A Glance

Good To Know

Q: Is this throttle body cable-driven or drive-by-wire? A: It is set up with a throttle cable connection, so it suits cable-driven LS builds rather than electronic throttle setups. Check your intake and pedal configuration before ordering.

Q: Will a 102mm throttle body bolt to my LS intake? A: It uses a four-bolt flange, so it must match the intake manifold bolt pattern on your GM Gen III LS1, LS2, or LS6 setup. Confirm the flange style before purchase.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.