4"x4" Rear Bumper For RV Camper Standard Bumper Reinforcement Bar W/Bumper Plugs

4"x4" Rear Bumper Reinforcement Bar for RV Camper

This 4"x4" rear bumper reinforcement bar is a direct replacement for standard RV and camper bumper setups, paired with bumper plugs to finish the install cleanly.

Overview

This 4"x4" rear bumper reinforcement bar is built as a standard replacement for RV and camper bumper assemblies. The reinforcement bar adds structural support at the rear of the coach, and the included bumper plugs seal the open ends for a finished appearance. It is aimed at RV owners replacing a bent, rusted, or missing rear bumper bar on a standard 4 inch by 4 inch setup.

Built For Performance

• 4 inch by 4 inch square profile matches standard RV and camper bumper mounting points
• Reinforcement design adds rigidity across the rear of the coach
• Bumper plugs included to close off open bumper ends
• Designed as a bolt-on replacement for worn or damaged rear bars
• Square tube construction suited to holding sewer hose or accessory carriers

On-The-Job Use

• Replacing a bent or rusted rear bumper bar on a travel trailer or motorhome
• Restoring rear structural support after a bumper impact
• Finishing a rear bumper install with sealed ends using the supplied plugs
• Adding a rear mounting surface for hose carriers and small accessories

Specs At A Glance

Good To Know

Q: Will this bar fit my camper's existing rear bumper mounts? A: It is made for standard 4 inch by 4 inch RV and camper bumper setups, so check your existing bar dimensions and mounting points before ordering.

Q: Do I need the bumper plugs? A: They are included to seal the open ends of the square tube, which keeps debris and moisture out of the bumper interior.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.