4PC Rubber Isolator Shock Mount For Stanley Bobcat Hydraulic Vibratory Compactor

4PC Rubber Isolator Shock Mount for Stanley Bobcat Hydraulic Vibratory Compactor

These 4PC rubber isolator shock mounts fit for Stanley and for Bobcat hydraulic vibratory compactors, replacing worn or cracked factory isolators to cut vibration transfer between the compaction drum and the machine frame.

Overview

This four piece rubber isolator shock mount set fits for Stanley and for Bobcat hydraulic vibratory compactors, serving as the flexible buffer between the vibratory drum assembly and the mounting bracket. Each rubber isolator shock mount absorbs the rapid oscillation produced during compaction so the carrier and surrounding hardware are not punished by constant vibration. The set suits operators servicing their own equipment as well as shops that maintain a fleet of hydraulic vibratory compactors.

Built For Performance

• Bonded rubber construction resists cracking under repeated compression cycles
• Sold as a matched four piece set so all isolators are replaced together
• Direct fit for the mounting points used on for Stanley and for Bobcat vibratory compactor drums
• Dampens high frequency oscillation before it reaches the machine frame
• Steel core inserts hold bolt torque without crushing the rubber body
• Serviceable wear item that restores original vibration control

Fits These Machines

• for Stanley hydraulic vibratory compactors
• for Bobcat hydraulic vibratory compactors

On-The-Job Use

• Road and lot repair crews running hydraulic vibratory compactors
• Utility and trench backfill compaction on construction sites
• Rental fleet maintenance and vibration isolation replacement
• Preventive service before cracked isolators damage the drum bracket

Specs At A Glance

Good To Know

Q: How do I know the isolators need replacing? A: Excessive drum vibration, visible cracks in the rubber, or loosened mounting hardware are the usual signs that the isolators have broken down. Replacing them as a set keeps vibration control even across all mounting points.

Q: Can these be installed one at a time? A: They can be fitted individually, but isolators of the same age wear at a similar rate, so swapping the full set at once is the more practical approach. Always confirm the mounting bolt pattern matches your drum assembly before installing.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.