4Pcs Left & Right Camshaft Set For Chrysler 200 300 Dodge Ram 3.6L V6 Pentastar

Left & Right Camshaft Set for Chrysler 200 300 Dodge Ram

This four piece left and right camshaft set fits 3.6L V6 Pentastar engines and drives valve opening and closing so the engine holds factory timing and power.

Overview

The left and right camshaft set provides four cams to service both cylinder banks of the 3.6L V6 Pentastar. Each camshaft is ground to original lobe profiles so valve lift and duration stay within factory spec. This camshaft set suits engine builders, shops, and owners handling a top-end repair.

Built For Performance

• Four camshafts cover both banks in a single set
• Intake and exhaust lobes ground to original lift and duration
• Hardened journals resist wear under constant spring pressure
• Factory dimensions allow direct replacement fitment
• Balanced cores help limit vibration at higher rpm

Fits These Machines

• for Chrysler 200 with 3.6L V6
• for Chrysler 300 with 3.6L V6
• for Dodge Ram 1500 with 3.6L V6
• for Dodge Charger with 3.6L V6
• for Dodge Challenger with 3.6L V6
• for Jeep Grand Cherokee with 3.6L V6

On-The-Job Use

• Camshaft replacement after lobe or journal wear
• Timing chain and phaser service on 3.6L engines
• Top-end overhauls and long block builds
• Fleet and daily driver engine repairs

Specs At A Glance

Good To Know

Q: Can these camshafts be installed without removing the cylinder heads? A: On most 3.6L Pentastar engines the cams sit under the cam covers and can be serviced from the top. Check your model's service procedure before starting.

Q: Should cam phasers be replaced at the same time? A: Worn phasers can undo the benefit of new camshafts. Many technicians replace them along with the cams and timing components.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.