4Pcs New Stainless Lap Joint Exhaust Clamp Sleeve Band For 2.5" 2 1/2" OD Pipe

Stainless Lap Joint Exhaust Clamp Sleeve Band for 2.5" OD Pipe

This four-piece set of stainless lap joint exhaust clamps, sleeve bands is made to join 2.5 inch outside diameter exhaust pipe sections with a secure, leak-resistant seal.

Overview

These stainless lap joint exhaust clamps act as sleeve bands that seal and secure exhaust piping at 2.5 inch outside diameter joints. Each clamp tightens around the pipe overlap to hold sections together without welding. They suit exhaust repairs, custom builds, and muffler or pipe replacements.

Built For Performance

• Stainless steel construction resists corrosion and heat
• Lap joint sleeve band design seals overlapping pipe sections
• Clamps fit 2.5 inch or 2 1/2 inch outside diameter pipe
• Bolt-tightened band holds joints without welding
• Four-piece set for multiple connections in one job

On-The-Job Use

• Joining exhaust pipe sections during repairs
• Muffler and resonator replacements
• Custom exhaust fabrication and band clamp connections
• Securing slip joints on 2.5 inch OD piping

Specs At A Glance

Good To Know

Q: Will these work on 2.5 inch outside diameter pipe? A: Yes, these sleeve band clamps are sized for 2.5 inch or 2 1/2 inch outside diameter exhaust pipe. A: Verify your pipe's measured outside diameter before ordering.

Q: Do these require welding? A: No, these lap joint clamps bolt on to seal overlapping pipe sections. A: A lap joint connection allows the pipes to slip together before tightening.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.