4x Front Rear Air Suspension Struts For 2016-20 BMW G11 G12 740i 750i 750Li RWD

Front and Rear Air Suspension Struts for BMW G11 G12 740i 750i 750Li RWD

This set of four air suspension struts replaces the front and rear air springs on rear-wheel-drive BMW G11 and G12 7 Series models, supporting factory ride height and load leveling.

Overview

These air suspension struts are direct-fit replacement units for the front and rear corners of rear-wheel-drive G11 and G12 7 Series cars. Each strut uses an air spring and damper assembly to carry vehicle weight, absorb road input, and maintain ride height under load. The set is built for owners addressing a sagging corner, a failed air spring, or a full suspension refresh.

Built For Performance

• Set of four struts covering both front and both rear positions
• Air spring and damper assembly for load leveling and ride height control
• Reinforced rubber air sleeve resists cracking and leaks
• Corrosion-resistant housing suited to daily road exposure
• Designed for direct replacement at the factory mounting points
• Rear-wheel-drive fitment matched to the listed 7 Series models

Fits These Machines

• for BMW 740i G11 RWD (2016-2020)
• for BMW 750i G11 RWD (2016-2020)
• for BMW 750Li G12 RWD (2016-2020)

On-The-Job Use

• Replacing a leaking or collapsed air spring at one or more corners
• Correcting uneven ride height or a sagging rear end
• Refreshing worn suspension on a high-mileage 7 Series
• Servicing the air suspension system after a compressor or valve fault

Specs At A Glance

Good To Know

Q: Will these fit an xDrive model? A: This set is listed for rear-wheel-drive G11 and G12 models, and xDrive cars use different strut fitment. Verify your drivetrain and chassis code before ordering.

Q: Do I need to reset anything after installation? A: Air suspension systems usually need a ride height calibration or relearn procedure after new struts are fitted. A scan tool capable of accessing the suspension module is recommended.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.