4x Front & Rear Wheel Bearing For Can-Am UTV Maverick X3 MAX R RR 4x4 2017-2023

Front & Rear Wheel Bearings for Can-Am UTV Maverick X3 MAX R RR 4x4

This set of four wheel bearings is built to replace worn hub bearings on Can-Am UTV Maverick X3 MAX R RR 4x4 models, restoring smooth rotation at both the front and rear corners.

Overview

This four-piece wheel bearing kit serves Can-Am UTV Maverick X3 MAX R RR 4x4 machines from 2017 through 2023, covering both front and rear hub positions in one order. Each bearing is made to support the constant loads a side-by-side puts on its hubs, so you can refresh the whole machine instead of chasing one corner at a time. It is aimed at owners and shops doing routine hub service or replacing bearings that have started to growl, rumble, or show play.

Built For Performance

• Sealed bearing design keeps grease in and grit out of the rolling elements
• Four bearings in the set, enough to service front and rear hub positions together
• Machined races and hardened steel construction for steady load carrying
• Direct-fit dimensions matched to the Can-Am UTV Maverick X3 MAX R RR 4x4 hub bore
• Suited to the higher loads of 4x4 UTV drivetrains

Fits These Machines

• for Can-Am Maverick X3 MAX R RR 4x4 2017
• for Can-Am Maverick X3 MAX R RR 4x4 2018
• for Can-Am Maverick X3 MAX R RR 4x4 2019
• for Can-Am Maverick X3 MAX R RR 4x4 2020
• for Can-Am Maverick X3 MAX R RR 4x4 2021
• for Can-Am Maverick X3 MAX R RR 4x4 2022
• for Can-Am Maverick X3 MAX R RR 4x4 2023

On-The-Job Use

• Trail riding where water crossings and dust work their way into hub assemblies
• Dune and desert running that keeps wheel bearings under sustained heat and load
• Routine hub service before a riding season
• Shop repair when a bearing shows noise or play at the wheel

Specs At A Glance

Good To Know

Q: How do I know if my wheel bearings need replacing? A: Common signs include grinding or humming that changes with speed, wobble or play when the wheel is rocked by hand, and uneven tire wear. Catching it early prevents hub and spindle damage.

Q: Do I need to replace all four at once? A: Not strictly, but bearings on the same machine tend to wear at a similar rate, so servicing all four in one job saves repeat teardown time. This set is sized for exactly that.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.