5 Ton Self-Tightening Grips Auto Body Repair Pull Clamp Tool 2-Way Frame Back

5 Ton Self-Tightening Grips Auto Body Repair Pull Clamp Tool

This 5 ton self-tightening grip is a two-way auto body pull clamp that locks onto panels and frame sections so a slide hammer or pulling rig can straighten damaged metal.

Overview

This 5 ton self-tightening grip is a two-way auto body repair pull clamp built to bite down on sheet metal and frame sections during collision work. As pulling force increases, the jaws tighten their hold, letting the operator pull dents, creases, and bent panels without welding on a stud. It suits body shop techs and DIY collision repair jobs where a strong, reusable grip point is needed.

Built For Performance

• Self-tightening jaw design increases clamping force as pull load rises
• 5 ton working capacity for heavier panel and frame pulling
• Two-way configuration allows pulls from either direction
• Hardened jaw teeth bite into metal for a non-slip hold
• Rugged steel body stands up to repeated slide hammer use

On-The-Job Use

• Pulling dents and creases on doors, fenders, and quarter panels
• Straightening frame rails and structural sections after a collision
• Working with a slide hammer or frame pulling rig on damaged vehicles
• Body shops and DIY collision repair where a reusable grip point is needed

Specs At A Glance

Good To Know

Q: Can this clamp be used with a standard slide hammer? A: Yes, the grip is designed to take pull force from a slide hammer or pulling rig through its attachment point. Match the pull direction to the two-way clamp layout for the best hold.

Q: Will the jaws mark the panel surface? A: The hardened teeth are made to bite for grip, so some marking at the contact point is expected on painted panels. That area is normally worked and refinished as part of the repair.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.