725-06173 Clutch Harness 11" Fit for MTD Super Bronco Hydro 50 54 46XP 50XP 54

Clutch Harness 11" for MTD Super Bronco Hydro 50 54 46XP 50XP 54

This 11-inch clutch harness for MTD Super Bronco Hydro 50 54 46XP 50XP 54 is the wiring assembly that connects the PTO clutch to the mower's electrical system. It is a direct replacement for OEM part 725-06173, ensuring proper blade engagement on compatible MTD hydrostatic tractors.

Overview

This clutch harness 11" for MTD Super Bronco Hydro models carries the electrical signal from the switch to the PTO clutch, enabling the mower deck to start and stop blades. It is used on the Super Bronco Hydro 50, 54, 46XP, 50XP, and 54 models. This harness restores factory-correct wiring integrity for reliable operation.

Built For Performance

• 11-inch length fits factory wire routing
• Replaces OEM part number 725-06173 exactly
• Pre-attached terminals for quick connection
• Heat-resistant jacket protects engine bay wiring
• Direct-fit connectors match MTD factory plugs

Fits These Machines

• for MTD Super Bronco Hydro 50
• for MTD Super Bronco Hydro 54
• for MTD Super Bronco 46XP
• for MTD Super Bronco 50XP
• for MTD Super Bronco 54

On-The-Job Use

• Replaces a corroded or melted clutch harness on hydrostatic models
• Used when the blade engagement switch shows continuity but the clutch does not activate
• Wired along the frame under the battery tray

Specs At A Glance

Good To Know

Q: Can this harness be installed without cutting wires? A: Yes, the harness uses factory-style connectors, so you can unplug the old one and plug in the new one directly.

Q: What causes a clutch harness to fail? A: Vibration and heat can wear down insulation, or the connector pins may corrode, leading to poor contact and intermittent clutch performance.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.