87106-0C140 Fit Toyota Tundra 2007-21 Sequoia 2008-21 Heater & A/C Damper Servo

Heater & A/C Damper Servo for Toyota

This heater & A/C damper servo, cross-referenced as 87106-0C140, is a replacement blend door actuator that controls airflow temperature and direction in the cabin. It is designed for Toyota Tundra 2007-21 and Sequoia 2008-21 models.

Overview

This heater & A/C damper servo is a direct replacement actuator governing the internal air mixing doors in your climate control system. It is for Toyota Tundra and Sequoia models, ensuring accurate temperature and mode selection. The servo responds to your dash controls to redirect hot or cold air as needed.

Built For Performance

• Precision-machined gear train for smooth, quiet operation
• Direct-fit connector mates with factory wiring harness
• Reinforced housing resists cracking from temperature cycling
• Verified torque output meets OEM specifications
• Tested across full range of travel for consistent positioning

Fits These Machines

• for Toyota Tundra 2007-2021
• for Toyota Sequoia 2008-2021

On-The-Job Use

• Replaces a failed actuator causing clicking noises or no airflow change
• Used when heating or cooling output is stuck on one setting
• Installed during HVAC repair after dash removal

Specs At A Glance

Good To Know

Q: How do I know this actuator is faulty? A: Common signs include a repetitive clicking sound from the dashboard and no change in airflow temperature when adjusting the dial. The servo also fails to move the door if the internal motor gears strip.

Q: Can I install this myself? A: Yes, if you have basic tools and access to the HVAC housing behind the dash. Disconnect the battery, remove the old servo, then mount the new one and reconnect the harness.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.