8mm Black Rear View Mirrors For Harley FLSTC FXDB Dyna FXDF Left and Right

8mm Rear View Mirrors for Harley

These 8mm black rear view mirrors are a left and right pair built to replace the factory mirrors on a range of Harley models, giving you a clear view behind with a clean black finish. Sold as a set for both sides, they thread directly into standard 8mm mirror mounts and use the included hardware so installation stays straightforward.

Overview

These 8mm black rear view mirrors are a left and right set made to restore or refresh the rear visibility on bikes that use 8mm threaded mirror mounts. The pair offers a low-profile black look that suits the styling of Harley cruisers and Dyna models, and the 8mm black rear view mirrors mount with basic tools. Riders replacing stripped, cracked, or missing factory mirrors will find these 8mm black rear view mirrors a simple bolt-on solution for both sides of the handlebars.

Built For Performance

• Sold as a matched left and right pair so both sides get consistent styling
• 8mm threaded stems sized for standard handlebar mirror mounts
• Black finish that resists corrosion and blends with dark bar setups
• Housing and stem are rigid enough to hold adjustment over rough roads
• Glass provides a clear, wide view for lane changes and traffic checks
• Simple bolt-on installation with basic hand tools

Fits These Machines

• for Harley FLSTC Heritage Softail Classic
• for Harley FXDB Dyna Street Bob
• for Harley FXDF Dyna Fat Bob
• Any motorcycle running 8mm threaded mirror mounts

On-The-Job Use

• Routine replacement of damaged or missing factory mirrors
• Refreshing the look of older cruisers and Dyna models
• Commuting and highway riding where steady rearward vision matters
• Custom builds needing a matched black mirror set

Specs At A Glance

Good To Know

Q: Will these fit my specific Harley model? A: They fit machines that use 8mm threaded mirror mounts, including the FLSTC and Dyna models listed, but confirm your mount size before ordering since some models use different thread pitches.

Q: Do I need special tools to install them? A: No, these mirrors mount with standard hand tools by threading into the existing mirror bosses on the handlebar controls. Check that the threads start cleanly before tightening to avoid cross-threading.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.