8Pcs Front Lower Control Arms Sway Bars Tie Rods Kit for Nissan Maxima 2016-2023

Front Lower Control Arms Sway Bars Tie Rods Kit for Nissan Maxima

This 8-piece front suspension kit combines lower control arms, sway bar links, and tie rods to restore steering response and ride stability on Nissan Maxima models from 2016 through 2023.

Overview

This 8Pcs front lower control arms sway bars tie rods kit delivers the core front-end components needed to refresh worn suspension and steering parts on Nissan Maxima vehicles. Each piece is engineered to match original mounting points, helping return alignment, handling, and steering feel to spec. It suits DIY installers and shops handling routine front-end rebuilds on 2016-2023 Maxima models.

Built For Performance

• Includes both front lower control arms with pressed-in bushings and ball joints
• Pair of sway bar links to tighten body roll and cornering stability
• Inner and outer tie rod ends for restoring precise steering response
• Forged and cast steel construction built to handle daily driving loads
• Corrosion-resistant finish helps resist road salt and moisture
• Direct-fit geometry designed to align with factory mounting locations

Fits These Machines

• for Nissan Maxima 2016
• for Nissan Maxima 2017
• for Nissan Maxima 2018
• for Nissan Maxima 2019
• for Nissan Maxima 2020
• for Nissan Maxima 2021
• for Nissan Maxima 2022
• for Nissan Maxima 2023

On-The-Job Use

• Front-end rebuilds after clunking or wandering steering develops
• Alignment restoration following worn bushing or tie rod replacement
• Everyday commuting and highway driving where steering precision matters
• Preventive suspension maintenance on higher-mileage Maxima sedans

Specs At A Glance

Good To Know

Q: Does this kit require an alignment after installation? A: Yes, a professional alignment is recommended once the control arms and tie rods are installed so the front-end geometry is set correctly.

Q: Are the bushings and ball joints already pressed into the control arms? A: The control arms come with bushings and ball joints pre-installed, which simplifies the swap and reduces install time.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.