92400ZW10A For 2004-2015 Nissan Armada 5.6L HVAC Heater Inlet Hose Control Valve

HVAC Heater Inlet Hose Control Valve for Nissan Armada

This HVAC heater inlet hose control valve regulates coolant flow into the heater core on 2004 through 2015 Nissan Armada models with the 5.6L engine. Interchange reference 92400ZW10A identifies this as the heater inlet hose valve assembly for the Armada.

Overview

This heater inlet hose control valve controls the flow of hot coolant through the heater core so the cabin gets consistent warmth when you call for it. It installs inline on the inlet hose and responds to the climate control system. Built for Armada owners repairing a leaking valve, a no-heat condition, or a coolant drip under the hood.

Built For Performance

• Valve body constructed from durable molded material for long service life
• Controls coolant flow into the heater core for cabin temperature regulation
• Inline design matches the factory inlet hose location on the 5.6L engine
• Hose connection ends sized for the original inlet hose fit
• Vacuum or cable actuation matching the Armada climate control setup

Fits These Machines

• for Nissan Armada 2004
• for Nissan Armada 2005
• for Nissan Armada 2006
• for Nissan Armada 2007
• for Nissan Armada 2008
• for Nissan Armada 2009
• for Nissan Armada 2010
• for Nissan Armada 2011
• for Nissan Armada 2012
• for Nissan Armada 2013
• for Nissan Armada 2014
• for Nissan Armada 2015

On-The-Job Use

• Replacing a valve that has begun leaking coolant onto the engine
• Fixing a no-heat or weak-heat complaint tied to coolant flow
• Completing a heater hose or heater core repair job
• Servicing the cooling system on a high mileage 5.6L Armada

Specs At A Glance

Good To Know

Q: Will I lose coolant when replacing this valve? A: Yes, the cooling system is under pressure and coolant will drain when the inlet hose is opened. Clamp the hose or drain the system first, then refill and bleed the cooling system after the new valve is installed.

Q: Is this an original Nissan part? A: No, this is an aftermarket heater inlet hose control valve offered as an alternative to the factory part and referenced by the 92400ZW10A interchange number. It is not made by or affiliated with Nissan.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.