Active Grille Shutter with motor for Chevy 84652494 Chevrolet Silverado 1500 LT
Active Grille Shutter with motor for Chevy 84652494 Chevrolet Silverado 1500 LT
Couldn't load pickup availability
Active Grille Shutter with Motor for Chevy
This active grille shutter with motor is a front grille airflow control assembly cross-referenced to part number 84652494 for the Chevrolet Silverado 1500 LT, regulating air through the grille to aid engine warm-up and aerodynamics.
Overview
This active grille shutter with motor is a complete front-end air control assembly built to replace the factory unit on the Chevrolet Silverado 1500 LT. The motorized vanes open and close automatically to control airflow into the engine bay. It suits owners replacing a broken or inoperative grille shutter.
Built For Performance
- Electric motor included to drive the shutter vanes
- Direct-fit mounting layout matching the factory grille opening
- Durable vane and frame construction for repeated open and close cycles
- Motor housing sealed against dust, water splash, and road grime
- Cross-references part number 84652494
Fits These Machines
- for Chevrolet Silverado 1500 LT
On-The-Job Use
- Replacing a seized or failed grille shutter on a daily-driven truck
- Repairing front-end damage that affects the grille air control
- Restoring automatic airflow control for faster engine warm-up
- Clearing shutter-related fault codes tied to the grille assembly
Specs At A Glance
| Part Number(s) | 84652494 |
| Type | Active grille shutter with motor |
| Motor | Included, electric |
| Position | Front grille air control |
| Fitment | for Chevrolet Silverado 1500 LT |
Good To Know
Q: Will this shutter need a calibration after it is installed? A: Some trucks require a relearn procedure so the control module recognizes the new motor, so consult your service information before driving. Any stored grille shutter codes should be cleared and rechecked afterward.
Q: What usually causes a grille shutter to stop working? A: Broken vanes, a failed motor, or debris jammed in the frame are the most common causes. Inspecting the vanes and motor connector helps confirm whether the whole assembly needs replacement.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
