Aluminum Car Battery Tie Down Mount Bracket Brace Bar & 10 Inch J Bolts

Aluminum Battery Tie Down Bracket Brace Bar with 10 Inch J Bolts

This aluminum battery tie down mount bracket brace bar with 10 inch J bolts secures your battery in place so it stays put through vibration and rough roads.

Overview

This aluminum battery tie down mount bracket brace bar holds a standard automotive battery firmly against its tray. The included 10 inch J bolts hook under the tray lip while the top bar clamps across the battery case. It is a practical pick for anyone replacing a rusted or missing factory hold-down.

Built For Performance

• Aluminum construction resists corrosion better than bare steel
• Top bar spans the battery case to limit forward and sideways movement
• 10 inch J bolts reach under common battery tray lips
• Lightweight design adds almost nothing to the front of the vehicle
• Simple two-bolt clamping setup that most owners can install with basic hand tools

On-The-Job Use

• Replacing a corroded or snapped factory battery hold-down
• Securing a battery in a project car or rebuilt engine bay
• Track and autocross cars where battery movement must be controlled
• Daily drivers that see rough roads and constant vibration

Specs At A Glance

Good To Know

Q: Will this bracket fit my battery tray? A: It is made for standard automotive battery trays with a lip the J bolts can hook under. Measure your tray width and battery height before ordering to be sure the bar spans correctly.

Q: Do the J bolts come with the bracket? A: Yes, the 10 inch J bolts are included with the bracket bar. You supply the nuts and washers that thread onto the bolts if they are not already on your tray.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.