Aramid Clutch Drive Belt 36395-97 Fit for Columbia Par Car Parcar 1997-2004

Aramid Clutch Drive Belt for Columbia Par Car Parcar 1997-2004

This aramid clutch drive belt 36395-97 is a direct replacement drive belt for Columbia Par Car Parcar golf carts built from 1997 through 2004, transferring engine power to the transaxle for consistent forward motion. This aramid clutch drive belt delivers reliable engagement and strong grip for daily cart use. Replacing a worn aramid clutch drive belt restores acceleration and prevents belt slippage during hill climbs.

Overview

This drive belt is constructed with aramid cord for high-strength power transmission in Columbia Par Car Parcar 1997-2004 models. It replaces the original belt's function, ensuring the clutches open and close smoothly as speed changes. The belt is engineered to match the dimensions and flex characteristics required for dependable golf cart operation.

Built For Performance

• Aramid tension cords provide high tensile strength and resistance to stretching
• Wrapped construction reduces edge wear and extends service life
• Optimized width and length for proper clutch-to-clutch ratio on Parcar models
• Heat-resistant rubber compound handles continuous load and high rpm
• Precision-cut cogs offer flexible operation around small diameter pulleys

Fits These Machines

• for Columbia Par Car Parcar 1997
• for Columbia Par Car Parcar 1998
• for Columbia Par Car Parcar 1999
• for Columbia Par Car Parcar 2000
• for Columbia Par Car Parcar 2001
• for Columbia Par Car Parcar 2002
• for Columbia Par Car Parcar 2003
• for Columbia Par Car Parcar 2004

On-The-Job Use

• Used on golf courses for daily cart operation
• Suitable for resort and hospitality transport vehicles
• Works for campground and senior living community carts
• Handles stop-and-go driving on hilly terrain

Specs At A Glance

Good To Know

Q: How do I know if this belt is the right size for my Parcar? A: Check the original belt's part number printed on the side; if it reads 36395-97 then this belt matches the same length and width as the factory spec.

Q: How often should the drive belt be replaced on a Columbia Parcar? A: Typical replacement happens every 2 to 3 years or about 1,000 to 2,000 hours of operation, depending on loads and terrain.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.