Aramid Drive Clutch Belt 36395-97 Fit for Columbia Parcar Golf Cart 1997-2004

Aramid Drive Clutch Belt for Columbia Parcar Golf Cart

This aramid drive clutch belt 36395-97 is a replacement drive belt for Columbia Parcar golf carts from 1997 through 2004, transmitting power from the engine clutch to the rear axle for smooth movement. Featuring aramid fiber reinforcement, this aramid drive clutch belt resists stretching and tearing under heavy load. Installing this aramid drive clutch belt helps maintain correct clutch engagement and steady speed on the course.

Overview

This drive clutch belt is built to replace the original belt on Columbia Parcar golf carts, using aramid cord for long-lasting tension and grip. It engages the drive and driven clutches in sync to deliver smooth acceleration and consistent top speed. Designed for golf cart duty cycles, it handles frequent start-stop operation without excessive wear.

Built For Performance

• Aramid fiber cords resist elongation for consistent clutch ratio
• Cogged underside reduces heat buildup during continuous use
• Reinforced edges prevent fraying against clutch sheaves
• Flexible rubber compound for smooth engagement at low rpm
• Dimensionally stable for precise fit on stock clutches

Fits These Machines

• for Columbia Parcar Golf Cart 1997
• for Columbia Parcar Golf Cart 1998
• for Columbia Parcar Golf Cart 1999
• for Columbia Parcar Golf Cart 2000
• for Columbia Parcar Golf Cart 2001
• for Columbia Parcar Golf Cart 2002
• for Columbia Parcar Golf Cart 2003
• for Columbia Parcar Golf Cart 2004

On-The-Job Use

• Ideal for golf course carts running daily rounds
• Works for fleet carts at resorts and gated communities
• Suitable for maintenance carts on paved or packed dirt paths
• Handles towing light loads like trailers or utility wagons

Specs At A Glance

Good To Know

Q: What happens if I use a worn drive belt on my Columbia Parcar? A: A worn belt slips during acceleration and may cause the clutches to engage at the wrong ratio, leading to poor speed and higher fuel consumption.

Q: Can I install this belt myself? A: Yes, with basic hand tools you can remove the clutch cover, slide off the old belt, and wrap the new one around both clutches following the drive belt routing diagram.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.