Bearing Carrier Retainer Wrench Tool for Mercury Mercruiser Alpha Bravo 91-61069

Bearing Carrier Retainer Wrench Tool for Mercury Mercruiser

This bearing carrier retainer wrench tool is designed to remove and install the bearing carrier retainer ring on Mercury Mercruiser Alpha and Bravo sterndrives, cross-referencing OEM tool number 91-61069.

Overview

This bearing carrier retainer wrench tool is built to engage the retainer ring that holds the bearing carrier inside Mercury Mercruiser Alpha and Bravo sterndrive gear housings. It lets you break the retainer loose and torque it back to spec without damaging the ring or housing. It suits marine mechanics and DIY boat owners servicing lower units.

Built For Performance

• Cross-references OEM tool number 91-61069
• Designed to engage the bearing carrier retainer ring in Alpha and Bravo drives
• Allows removal and installation of the retainer without damaging the ring
• Rugged steel construction for repeated shop use
• Fits both Alpha and Bravo sterndrive families

Fits These Machines

• for Mercury Mercruiser Alpha sterndrives
• for Mercury Mercruiser Bravo sterndrives
• for Mercury Mercruiser Alpha One drives
• for Mercury Mercruiser Bravo One, Two, and Three drives

On-The-Job Use

• Lower unit teardown for bearing carrier service
• Seal and bearing replacement in the gear housing
• Driveshaft and gear set service on Alpha and Bravo drives
• Routine sterndrive maintenance in a marine shop or home garage

Specs At A Glance

Good To Know

Q: Will this tool work on both Alpha and Bravo drives? A: It is listed for Mercury Mercruiser Alpha and Bravo sterndrives and cross-references OEM tool 91-61069. Confirm your drive model before ordering.

Q: Is this an original Mercury tool? A: No, this is an aftermarket wrench tool that cross-references OEM number 91-61069. It is not an original Mercury Mercruiser product.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.