Bellows Kit for OMC Cobra 1986 & Later Volvo Penta SX-S SX-C SX-R SX-M DP-S

Bellows Kit for OMC and Volvo Penta

This bellows kit replaces the exhaust and drive shaft bellows for OMC Cobra stern drives from 1986 and later, as well as Volvo Penta SX-S, SX-C, SX-R, SX-M, and DP-S drives.

Overview

This bellows kit is a complete replacement set for worn or damaged bellows on OMC Cobra and Volvo Penta stern drives. It is designed for OMC Cobra models from 1986 onward and Volvo Penta SX series and DP-S drives, ensuring a reliable seal for the drive shaft and exhaust. The kit provides all necessary components for a professional-grade bellows replacement.

Built For Performance

• High-quality rubber compound resists ozone and saltwater damage
• Includes all required clamps and hardware
• Pre-formed to match original contours for a secure fit
• Designed to withstand high temperatures and flexing
• Compatible with multiple stern drive systems

Fits These Machines

• for OMC Cobra (1986 and later)
• for Volvo Penta SX-S
• for Volvo Penta SX-C
• for Volvo Penta SX-R
• for Volvo Penta SX-M
• for Volvo Penta DP-S

On-The-Job Use

• Installed during stern drive service to prevent water ingress
• Replaces cracked or deteriorated bellows that cause vibration
• Used in both inboard and outboard engine compartments
• Commonly part of a full drive shaft and exhaust overhaul

Specs At A Glance

Good To Know

Q: Is this bellows kit compatible with all OMC Cobra models after 1986? A: It is designed for OMC Cobra stern drives from 1986 onward, but you should verify your specific model and serial number.

Q: Does the kit include the clamps? A: Yes, the kit comes with all necessary clamps and hardware for installation.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.