Billet Knock Sensor Delete LSX LS1 For LS Gen 3 VALLEY PAN Cover & GASKET Plate

Billet Knock Sensor Delete for LSX LS1 LS Gen 3

This billet knock sensor delete is a valley pan cover and gasket plate for LSX, LS1, and LS Gen 3 engines that closes off the knock sensor locations when they are removed from the valley area.

Overview

This billet knock sensor delete plate for LSX, LS1, and LS Gen 3 engines mounts in the valley area to seal the knock sensor openings after those sensors have been removed. The billet valley pan cover blocks off the space cleanly and protects the lifter valley from debris on builds that no longer run factory knock sensors. It suits builders working on LS Gen 3 engine swaps and performance projects.

Built For Performance

• Billet construction for a rigid valve in the valley area
• Seals knock sensor openings after sensor removal
• Includes a gasket for a complete installation
• Fits LSX, LS1, and LS Gen 3 engine valley layout

On-The-Job Use

• LS Gen 3 engine rebuilds with sensors removed
• Engine swap builds simplifying the wiring harness
• Valley area clean-up on performance builds

Specs At A Glance

Good To Know

Q: Do I need to remove my knock sensors to use this plate? A: This delete plate replaces the knock sensor openings in the valley, so it is intended for builds that have removed those sensors.

Q: Does this plate fit all LS Gen 3 engines? A: It is listed for LSX, LS1, and LS Gen 3 engines, but valley layouts vary, so confirm your block before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.