Black 102MM Throttle Body with Position Sensors TPS IAC+Throttle Gas Cable Kits

102MM Throttle Body with Position Sensors and Cable Kits

This 102MM throttle body assembly includes position sensors plus throttle gas cable kits, replacing the factory unit on supported performance intake setups.

Overview

This 102MM throttle body is a direct fit style upgrade for engines that need more airflow than the stock unit provides. It ships with position sensors for TPS and IAC function plus throttle gas cable kits to complete the install. It suits engine builders and enthusiasts working on large displacement, boosted or naturally aspirated builds that have outgrown the original throttle body.

Built For Performance

• 102MM bore size for increased airflow over smaller stock units
• Integrated position sensors for throttle position and idle air control
• Throttle gas cable kits included for a complete install
• Black finish housing for a clean engine bay look
• Machined body with smooth bore for consistent tip in response

On-The-Job Use

• Naturally aspirated builds needing more air on a big bore intake
• Turbo and supercharged setups where flow capacity matters
• Engine swaps and intake manifold changes on cable throttle engines
• Street and track builds chasing throttle response and top end flow

Specs At A Glance

Good To Know

Q: Does this throttle body come with the sensors already fitted? A: Yes, throttle position and idle air control sensors are part of the assembly. Confirm connector style and pin count match your harness before ordering.

Q: Will a larger bore like this require a tune? A: Moving to a 102MM bore normally changes the airflow calibration on cable throttle setups. A retune or calibration check is commonly needed for stable idle and accurate fuel delivery.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.