Black Silicone Hose Elbow Coupler Joiner Pipe 2.5" to 2.5" 90° Degree Leg 102mm

2.5" Silicone Hose Elbow Coupler 90 Degree

This black silicone 90 degree elbow coupler joins two 2.5 inch pipes at a right angle and stands up to boost pressure, heat, and vibration in intake and charge piping.

Overview

This black silicone hose elbow coupler is a 90 degree joiner for connecting 2.5 inch piping runs in intake, intercooler, and charge air systems. The flexible silicone body absorbs movement while holding a secure seal under boost. It suits builders and mechanics assembling or repairing custom and factory pipework.

Built For Performance

• 90 degree bend allows tight routing around engine bay obstacles
• 2.5 inch to 2.5 inch inner diameter for straight-through pipe joining
• Four-ply silicone construction resists heat, oil, and pressure
• Reinforced layers help hold shape under boost and engine movement
• Leg length of 102mm per side gives solid clamp engagement
• Black finish blends with most engine bay setups

On-The-Job Use

• Connecting intercooler piping and charge air runs
• Intake plumbing on turbocharged or custom builds
• Repairing or replacing cracked rubber couplers
• Fabricating right-angle joints in 2.5 inch pipework

Specs At A Glance

Good To Know

Q: Do I need clamps with this coupler? A: Yes, this elbow slides over 2.5 inch piping or fittings and should be secured with hose clamps on both legs. Clamps are not included.

Q: Will this work on a pressurized boost system? A: Its reinforced silicone construction is intended for intake and charge piping on boosted engines. Confirm your pipe diameter and clearance for the 90 degree bend before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.