Brake Master Cylinder Clutch Perch For HONDA TRX 250 350 400 Rancher FourTrax

Brake Master Cylinder Clutch Perch for Honda TRX 250 350 400 Rancher FourTrax

This brake master cylinder and clutch perch assembly replaces the handlebar-mounted hydraulic unit on Honda TRX 250, 350, and 400 Rancher and FourTrax ATVs.

Overview

This brake master cylinder with integrated clutch perch restores lever feel and hydraulic control on Honda TRX Rancher and FourTrax models. It mounts at the handlebar and feeds brake fluid to the front system. Riders and shops working on 250, 350, and 400 class ATVs will find it a practical replacement for a failed original assembly.

Built For Performance

• Combined master cylinder and clutch perch simplifies handlebar setup
• Hydraulic piston and seals hold pressure for consistent lever response
• Reservoir cap and diaphragm keep fluid clean and contained
• Lever pivot and perch mount fit standard Honda ATV handlebars
• Corrosion-resistant finish stands up to mud, water, and trail debris

Fits These Machines

• for Honda TRX 250 Rancher
• for Honda TRX 350 Rancher
• for Honda TRX 400 Rancher
• for Honda TRX 250 FourTrax
• for Honda TRX 350 FourTrax
• for Honda TRX 400 FourTrax

On-The-Job Use

• Replacing a leaking or seized master cylinder on a trail ATV
• Restoring clutch and brake control on Rancher and FourTrax models
• Handlebar rebuilds on work and utility ATVs
• Brake system service during routine maintenance

Specs At A Glance

Good To Know

Q: Is this an original Honda part? A: No, this is an aftermarket replacement made for Honda TRX models. Always verify the part numbers and mounting style against your original unit.

Q: What else do I need to complete the install? A: Fresh DOT brake fluid and a bleed kit are recommended to finish the job properly. Bleed the system after mounting to remove trapped air.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.