Bulkhead Connector Kit Quick Connect/Disconnect, for LiveScope 010-13350-00

Bulkhead Connector Kit for LiveScope

This bulkhead connector kit provides a quick connect and disconnect point for routing LiveScope transducer cabling through a boat hull or panel, and it references 010-13350-00.

Overview

This bulkhead connector kit gives boat riggers a clean pass-through for LiveScope cable runs. The quick connect and disconnect design lets the cable be separated at the hull or panel without pulling the full run. It suits anglers and installers setting up LiveScope sonar systems.

Built For Performance

• Quick connect and disconnect design for fast cable separation
• Cross-references 010-13350-00 for easy part matching
• Bulkhead mount keeps the cable run sealed through hull or panel
• Compact fitting for tight rigging locations
• Suits LiveScope transducer cable routing

On-The-Job Use

• Routing LiveScope cabling through a boat hull
• Panel pass-throughs on fishing rigs
• Connecting and disconnecting sonar cable at the bulkhead
• New sonar installs and cable replacement jobs

Specs At A Glance

Good To Know

Q: What is this bulkhead connector kit used for? A: It provides a mountable pass-through point where LiveScope cable can be connected and disconnected at the hull or panel. That keeps rigging tidy and service access quick.

Q: Does the quick disconnect affect signal performance? A: A properly seated quick connect fitting maintains a solid cable connection when joined. Confirm it is fully locked before use.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.