Cam Shaft Camshaft Rocker Arm Head Valve Gasket For Polaris Worker 500 1999 2001

Camshaft Rocker Arm Head Valve Gasket for Polaris Worker 500

The camshaft rocker arm head valve gasket for Polaris seals the rocker arm and cylinder head area on the Worker 500, helping retain oil and protect the valvetrain.

Overview

This camshaft rocker arm head valve gasket is a sealing component for the rocker arm and cylinder head assembly on Polaris Worker 500 engines. The gasket for Polaris machines helps prevent oil leaks around the camshaft and valve area during normal operation. It is aimed at owners and technicians servicing the top end of the Worker 500.

Built For Performance

• Replacement sealing component for the rocker arm and head valve area
• Helps prevent oil seepage around the camshaft and valve cover
• Gasket material suited to engine heat and oil contact
• Shaped to match the mounting surface for a clean install
• Suited to routine top-end service and engine rebuilds

Fits These Machines

• for Polaris Worker 500 1999
• for Polaris Worker 500 2001

On-The-Job Use

• Top-end resealing on Worker 500 utility engines
• Camshaft and rocker arm service work
• Preventive maintenance during engine rebuilds
• Correcting oil weepage near the head and valve cover

Specs At A Glance

Good To Know

Q: Is this an original Polaris part? A: No, this is an aftermarket replacement gasket for Polaris applications and is not made by Polaris. Q: Will this fit both listed model years? A: It is listed for the 1999 and 2001 Worker 500, but verifying your serial number before ordering is recommended.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.