Carburetor For Ford Mustang Falcon 1963 1964 1965 - 1969 6 cyl 170/200 Engines

Carburetor for Ford Mustang Falcon

This carburetor is a replacement fuel metering component for Ford Mustang and Falcon models equipped with 170 or 200 cubic inch six-cylinder engines from 1963 through 1969.

Overview

This carburetor is designed to deliver the correct air and fuel mixture for 170 and 200 cubic inch six-cylinder engines in classic Ford Mustang and Falcon cars. It replaces a tired or faulty original unit and helps bring back consistent idle, smooth acceleration, and dependable cold starts. The carburetor fits 1963 through 1969 applications with the listed engine sizes.

Built For Performance

• Cast body built to handle underhood heat and vibration
• Metering calibrated for 170 and 200 cubic inch six-cylinder engines
• Mounting flange and throttle linkage positioned for direct fitment
• Fuel inlet and float bowl arranged for stock fuel lines
• Choke provision supports cold-start enrichment
• Throttle plates checked for smooth travel before shipment

Fits These Machines

• for Ford Mustang with 170 or 200 six-cylinder engine, 1963 to 1969
• for Ford Falcon with 170 or 200 six-cylinder engine, 1963 to 1969

On-The-Job Use

• Bringing a classic Mustang or Falcon six-cylinder back to daily driving
• Replacing a carburetor that hesitates, stalls, or floods
• Refresh work during engine bay detailing or rebuild
• Weekend cruising and car show driving in vintage Ford compacts

Specs At A Glance

Good To Know

Q: Is tuning required after this carburetor is installed? A: A basic idle speed and mixture adjustment is typical after mounting, since settings depend on engine condition and elevation.

Q: Does this carburetor work on both the 170 and 200 six-cylinder engines? A: Yes, the listing covers both engine sizes, but verify your model year and intake flange before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.