Crank Shafts Connecting Rod Bearing Kit for Hyundai Santa Fe Sport 2.4L 2013-18

Crankshaft Connecting Rod Bearing Kit for Hyundai

This crankshaft connecting rod bearing kit is a direct-fit replacement set for the 2.4L engine, restoring proper clearances between the crankshaft journals and connecting rods so oil pressure and rotation stay within spec.

The kit is intended for rebuilders, mechanics, and owners servicing the Hyundai Santa Fe Sport 2.4L engine.

Overview

This crankshaft connecting rod bearing kit for Hyundai is assembled for 2.4L engine rebuilds, replacing worn rod bearings that cause knocking, low oil pressure, or excessive clearance. Each bearing set in this connecting rod bearing kit is sized to match the crankshaft journals, so the rotating assembly can be torqued back to factory tolerances. It suits anyone rebuilding or refreshing a Hyundai Santa Fe Sport 2.4L engine from 2013 through 2018.

Built For Performance

• Bearing set sized for 2.4L crankshaft connecting rod journals
• Multi-layer construction for load and heat resistance
• Precision machined for consistent oil clearance
• Kit includes bearings for the full connecting rod set
• Suited to standard rebuild tolerances

Fits These Machines

• for Hyundai Santa Fe Sport 2.4L 2013
• for Hyundai Santa Fe Sport 2.4L 2014
• for Hyundai Santa Fe Sport 2.4L 2015
• for Hyundai Santa Fe Sport 2.4L 2016
• for Hyundai Santa Fe Sport 2.4L 2017
• for Hyundai Santa Fe Sport 2.4L 2018

On-The-Job Use

• Engine rebuilds and short block assembly
• Repairing rod knock or low oil pressure
• Bottom end refresh during timing or head service
• Crankshaft replacement jobs

Specs At A Glance

Good To Know

Q: How do I know this bearing kit fits my engine? A: Confirm your Santa Fe Sport runs the 2.4L engine and check the bearing size against your crankshaft journal measurements before ordering.

Q: Should bearings be measured before installation? A: Yes, always plastigauge the oil clearance during assembly, since bearing size must match the machined journal diameter.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.