CVT Clutch Drive Belt for Polaris RZR XP 1000 / RZR XP 4 1000 / General 1000

CVT Clutch Drive Belt for Polaris RZR XP 1000, RZR XP 4 1000, and General 1000

This CVT clutch drive belt is a replacement belt for Polaris RZR XP 1000, RZR XP 4 1000, and General 1000 side-by-sides, transferring power between the primary and secondary clutch to keep the drivetrain pulling strong.

Overview

This CVT clutch drive belt is made to replace a worn or failed belt on Polaris RZR XP 1000, RZR XP 4 1000, and General 1000 machines. It handles the torque transfer between clutches so acceleration stays smooth and predictable. It is a practical spare for riders and mechanics servicing these popular Polaris platforms.

Built For Performance

• Reinforced rubber construction for high-torque CVT use
• Shaped for consistent clutch engagement and smooth take-off
• Resists heat and friction during extended rides
• Accurate dimensions for a proper fit in the clutch sheaves
• Suited to stock and mildly modified drivetrains

Fits These Machines

• for Polaris RZR XP 1000
• for Polaris RZR XP 4 1000
• for Polaris General 1000

On-The-Job Use

• Trail riding and sand dune runs
• Utility and farm tasks
• Routine CVT service
• Replacing a glazed or frayed belt

Specs At A Glance

Good To Know

Q: What causes a CVT belt to wear out quickly? A: Excessive heat from clutch slipping, aggressive launches, and lack of airflow in dusty conditions are common causes. Keeping the clutch vents clean and avoiding prolonged slipping helps extend belt life.

Q: Can this belt be installed without special tools? A: In most cases the belt can be swapped with basic hand tools by removing the clutch cover and spreading the secondary sheave. Check your service manual for the exact procedure for your model.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.