Driveshaft Prop Shaft Assembly For 1999-2003 Lexus RX300 3.0 AWD 3710048010 Rear

Rear Driveshaft Prop Shaft Assembly for Lexus RX300

This rear driveshaft prop shaft assembly is a direct replacement part for Lexus RX300 AWD models, cross-referencing OEM part number 3710048010, and it transfers torque from the transfer case to the rear differential.

Overview

This rear driveshaft prop shaft assembly is built to replace a worn or damaged factory shaft on 1999-2003 Lexus RX300 3.0 AWD vehicles. The driveshaft prop shaft assembly restores smooth power delivery to the rear wheels, cutting down on vibration and driveline noise. It is aimed at owners and mechanics handling a direct OEM-style replacement for the Lexus RX300.

Built For Performance

• Balanced steel tube construction to reduce driveline vibration
• Precision-machined yokes for a secure, accurate fit
• Cross-references OEM part number 3710048010
• Factory-style spline and flange geometry for drop-in installation
• Corrosion-resistant finish for long service life
• Assembled and balanced as a complete unit for straightforward replacement

Fits These Machines

• for Lexus RX300 3.0 AWD 1999
• for Lexus RX300 3.0 AWD 2000
• for Lexus RX300 3.0 AWD 2001
• for Lexus RX300 3.0 AWD 2002
• for Lexus RX300 3.0 AWD 2003

On-The-Job Use

• Replacing a bent or unbalanced rear shaft after collision or off-road impact
• Fixing driveline vibration and clunking under acceleration
• Routine drivetrain refresh on higher-mileage AWD SUVs
• Restoring rear-wheel power delivery on all-wheel-drive models

Specs At A Glance

Good To Know

Q: Does this driveshaft fit both AWD and FWD RX300 models? A: This assembly is intended for the AWD configuration listed in the title, so confirm your drivetrain before ordering. Front-wheel-drive models use a different setup and are not covered here.

Q: Will I need new hardware or a balancing service? A: The shaft comes assembled and balanced, but reusing original bolts and inspecting the flange and center support during install is good practice. A torque check after the first few drives helps catch any settling.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.